Advertisement
Home appliances and smart home

Range hood weak suction: what should you check and clean?

When a range hood has weak suction, start with the grease filters and the charcoal filter. If they are clean, check the duct, the backdraft damper and the air supply.

6 min read

Kitchen appliance with a drop of grease, a magnifying glass and a repair wrench
Table of contents
  1. Common symptoms and causes
  2. Before you start
  3. Solution 1: clean the metal grease filters
  4. Solution 2: replace the charcoal filter (recirculating hood)
  5. Solution 3: check the exhaust duct and the backdraft damper
  6. Solution 4: check the air supply and the motor
  7. If nothing works
  8. Take better care of your cooker hood: our toolbox
  9. Frequently asked questions
    1. Why is my range hood not pulling air anymore?
    2. How often should you change a range hood charcoal filter?
    3. How do you clean the grease filters of a range hood?
    4. How can you tell if the hood motor is dead?

This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.

When a range hood stops pulling air, start with the filters. Filters clogged with grease cut the suction, and the metal filter clogs first. If they are clean, check the exhaust duct, the backdraft damper, the air coming into the kitchen, and last the motor.

Advertisement

Common symptoms and causes

It depends on the type of hood. A ducted hood sends the air outside through a duct and has only a metal filter, which traps grease. A recirculating (ductless) hood cleans the air and sends it back into the room: it adds an activated charcoal filter, which traps odors.

  • Clogged grease filters: the suction drops gradually.
  • Clogged charcoal filter (recirculating hoods): the suction weakens and odors linger.
  • Exhaust duct blocked, pinched, too bendy or too narrow.
  • Dirty backdraft damper stuck shut (a user report, not confirmed by the manufacturer).
  • Not enough air coming into the kitchen.
  • Failing motor or capacitor, a lead our official sources do not detail.

Also check the size of the hood. According to Bosch, its recommended capacity is at least 6 times the volume of the room.

Good to know: the logic is the same as for a vacuum cleaner that has lost suction. You check what clogs first, then the path of the air.

Before you start

Keep your hood’s manual at hand: how the filters come off changes from one model to another. Write down the exact model number, which you need to order a replacement filter. Also note whether your hood is ducted or recirculating.

Warning: unplug the appliance from the mains before opening anything, by switching off the circuit breaker or pulling the plug; never work on a plugged-in appliance; the capacitors in some appliances (TVs, microwaves, power supplies) stay charged after unplugging, so do not touch them. Wait until the cooktop is cold. Do not work on the motor or the electrical parts of the hood: leave them to a professional.

The paper towel test tells you whether the filters are the problem.

Advertisement
  1. Turn the hood on.
  2. Hold a sheet of paper towel against the intake area.
  3. Let go of the sheet and watch it.

If the sheet stays stuck, the filters are not clogged: with a ducted hood, go to solutions 3 and 4; with a recirculating hood, go to solution 4, and replace the charcoal filter (solution 2) if odors persist. If it falls, clean or replace the filters (solutions 1 and 2).

Tip: you can test the air supply from solution 4 right away. Open a window with the hood running.

Solution 1: clean the metal grease filters

Metal filters can be washed, in the dishwasher or by hand. Cut the power to the hood before taking them out.

  1. Take out the metal filters following your model’s manual.
  2. Soak them for 15 to 20 minutes in a bath of degreaser.
  3. With a dishwasher: put them in alone, with no other dishes.
  4. Run a wash cycle, using the program given in your hood’s manual.
  5. Without a dishwasher, instead of steps 3 and 4: scrub them after soaking.
  6. Rinse them well.

Put the filters back, restore the power and repeat the paper towel test. The sheet should stay stuck.

For the soak, here is a kitchen degreaser spray.

hotte-aspirante-n-aspire-plus-300x169 Range hood weak suction: what should you check and clean?

Starwax heavy-duty kitchen degreaser, 500 ml spray

Spray that dissolves cooked-on grease on cold or lukewarm surfaces, wiped off with a damp sponge. Rinse before the surface touches food again.

hotte-aspirante-n-aspire-plus-1-1024x576 Range hood weak suction: what should you check and clean?
Washed grease filters, and the paper towel sheet stays stuck.

Good to know: the manufacturer’s sources give no washing temperature. Follow the one in your model’s manual. If you use the hood regularly, clean these filters once a month.

Advertisement

Solution 2: replace the charcoal filter (recirculating hood)

This solution only applies to recirculating hoods. The charcoal filter neutralizes odors. It cannot be washed: it has to be replaced.

Cut the power to the hood before you start. Removing and fitting the filter changes from one model to another: follow the manual.

  1. Check that your hood runs in recirculating mode, with an activated charcoal filter in addition to the metal filter.
  2. Note the exact model number of your hood.
  3. Order the charcoal filter that matches this model number.
  4. Remove the used filter following the manual, without trying to wash it.
  5. Fit the new filter in its place, again following the manual.

Restore the power and repeat the paper towel test. The sheet should stay stuck, a sign that the filters are no longer clogged.

If your hood’s filter is no longer sold, here are two universal filters that you cut to the size of the original.

  • HEYNNA universal 2-in-1 activated carbon and grease filter for cooker hoodsCut-to-size filter with an activated carbon side against odours and a side that traps grease. To be replaced regularly on a recirculating hood.AmazonSee at Amazon
  • M&H-24 cut-to-size activated carbon cooker hood filter, 60 cmCut-to-size filter with an activated carbon side against odours and a white side that traps grease. To be replaced regularly on a recirculating hood.AmazonSee at Amazon

Warning: at Bosch, a CleanAir module filter is not interchangeable with a standard charcoal filter. Always order by the exact model number of the hood.

Bosch advises replacing a standard charcoal filter every 6 months, and a CleanAir module filter every 12 months. Check the interval in your brand’s manual. Replace it sooner if odors persist.

Solution 3: check the exhaust duct and the backdraft damper

This solution applies to ducted hoods. The duct carries the air from the hood to the outside. Steps 6 and 7 rest on one user’s report, not confirmed by the manufacturer.

  1. Check that the duct vents the air outdoors and is not connected to the home’s mechanical ventilation (VMC in France).
  2. Measure the duct diameter: Bosch recommends 150 mm (about 6 in), and never less than the hood’s outlet.
  3. Check the route against Bosch’s guidance: as few bends as possible, no bend within the first 30 cm (about 12 in) after the outlet, no right angles.
  4. Check that the duct is as short as possible and smooth inside.
  5. Check the joint between the duct and the wall sleeve: a large gap between the two reduces performance.
  6. Check that the duct is not pinched or blocked, and straighten it out if it is pinched.
  7. Check that the backdraft damper is not stuck or jammed by grease, and clean it if it is.

In that user’s report, cleaning the damper and straightening the duct was enough to bring the suction back. The damper is not covered by the manufacturer pages we read.

hotte-aspirante-n-aspire-plus-2-1024x576 Range hood weak suction: what should you check and clean?
Check the duct along its whole route, all the way to the wall sleeve.

Solution 4: check the air supply and the motor

A hood always needs an air intake in the kitchen. The motor comes last, and you check it without opening the hood.

  1. Turn the hood on and open the window closest to the cooktop, for a ducted hood.
  2. If the room has another heat source, such as a fireplace, ask a chimney sweep for advice before using the hood in ducted mode.
  3. Notice whether the motor runs normally while the hood is on.
  4. If the motor does not start or runs badly, do not open the hood: refer to the manual or to after-sales service.

If the suction comes back with the window open, the lack of incoming air was the cause: leave an air inlet open while you cook. According to user reports, if the motor runs normally, the filter remains the main suspect. Go back to solutions 1 and 2.

If nothing works

Stop when the filters are clean or new, the duct is clear, the incoming air is sorted and the suction is still weak. Also stop at the slightest unusual noise or motor smell. Diagnosing the motor, the capacitor and the fan speeds is a job for after-sales service.

Contact the manufacturer’s support or the installer of the hood. Have the exact model number ready, along with the list of checks you have already done: filters, duct, damper, air supply.

The same habits work for other kitchen appliances, for example an oven that no longer heats.

Take better care of your cooker hood: our toolbox

A few products to keep a cooker hood efficient and clean it with no effort.

  • HEYNNA universal 2-in-1 activated carbon and grease filter for cooker hoodsCut-to-size filter with an activated carbon side against odours and a side that traps grease. To be replaced regularly on a recirculating hood.AmazonSee at Amazon
  • Starwax heavy-duty kitchen degreaser, 500 ml spraySpray that dissolves cooked-on grease on cold or lukewarm surfaces, wiped off with a damp sponge. Rinse before the surface touches food again.AmazonSee at Amazon
  • Vileda Colors: 8 microfibre clothsEight reusable microfibre cloths that pick up dust without scratching. Handy for wiping plastic parts and dust containers.AmazonSee at Amazon
  • Sanggi: long flexible brush for condenser and radiatorLong, thin brush that reaches dust between fins and grilles. Use it with the appliance switched off.AmazonSee at Amazon

Frequently asked questions

Why is my range hood not pulling air anymore?

Most often, the filters are clogged with grease, and the metal filter clogs first. The paper towel test confirms it. If the filters are clean, check the duct, the backdraft damper and the air coming into the kitchen.

How often should you change a range hood charcoal filter?

At Bosch, every 6 months for a standard charcoal filter and every 12 months for a CleanAir module filter. Check the interval in your brand’s manual, and replace it sooner if odors persist. A charcoal filter cannot be washed.

How do you clean the grease filters of a range hood?

Soak them for 15 to 20 minutes in a degreaser, then run them through the dishwasher on their own. Without a dishwasher, scrub them after soaking and rinse them well. With regular use, clean them once a month.

How can you tell if the hood motor is dead?

This diagnosis is for after-sales service: none of the official sources we read detail it. According to user reports, if the motor runs normally, the filter remains the main suspect. Do not open the hood to test the motor yourself.

Share this content:

Leave a Reply

Your email address will not be published. Required fields are marked *