Advertisement
Home appliances and smart home

Microwave not heating: what to check before replacing it?

A microwave that runs without heating can come from a setting, demo mode, the door, the socket or the ventilation. Here are the checks to make without opening the appliance, before you call customer support.

5 min read

Microwave oven with a warning sign, a magnifying glass and an electrical plug
Table of contents
  1. Common symptoms and causes
  2. Before you start
  3. Solution 1: test the heating with a glass of water
  4. Solution 2: check the program, the time and the power level
  5. Solution 3: leave demo mode
  6. Solution 4: check the door and how it closes
  7. Solution 5: check the socket and the ventilation
  8. If nothing works
  9. Take better care of your microwave: our toolbox
  10. Frequently asked questions
    1. Why does my microwave run but no longer heat?
    2. How do I test whether a microwave still heats?
    3. Can a microwave that no longer heats be repaired?
    4. Can the microwave fuse stop it from heating?

This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.

Your microwave runs, the light is on and the plate turns, but the food stays cold? Before blaming an internal part, check a setting, demo mode, the door, the socket and the ventilation. You need no tools and you never open the appliance.

Advertisement

Work through the solutions in order. Stop as soon as the microwave heats again.

Common symptoms and causes

  • The microwave starts and the plate turns, but the food stays cold: demo mode, the kitchen timer started instead of a cooking cycle, a door that is not fully shut, poor ventilation, or an internal high-voltage fault.
  • The timer counts down much faster than usual: demo mode is on.
  • Sparks or a burning smell: stop the appliance and cut the power without touching anything inside.

For a regular oven, see our guide on an oven that no longer heats.

Before you start

  • Note the model number from the label on the appliance.
  • Keep the manual for your model within reach: how to leave demo mode and the ventilation clearances differ from one model to another.

Warning: unplug the appliance from the mains before opening it, and never work on a plugged-in appliance. The capacitors in some appliances (TVs, microwaves, power supplies) stay charged after unplugging, so do not touch them. A microwave’s high-voltage capacitor can hold a dangerous charge even when unplugged: never open the cover and never touch any internal part, and never run a microwave empty.

Warning: opening the appliance can void the warranty, so check the warranty end date first. Contact the manufacturer first.

Every check in this guide is done without opening the appliance. The magnetron (the part that produces the microwaves), the capacitor, the diode, the control board and the fuse are a job for a technician.

Burning smell, sparks, overheating: stop the appliance at once and cut the power without touching the inside. Do not restart it to try again.

Advertisement

Solution 1: test the heating with a glass of water

  1. Put a microwave-safe glass of water in the cavity.
  2. Start a short cycle in standard microwave mode.
  3. Check the temperature of the water at the end of the cycle.
  4. If the display works, repeat the test with a second mode listed in the manual.

Water that stays cold after a normal cycle confirms a heating fault. The manufacturers we checked give no reference time or temperature for this test. Keep to one thing: the water either heated or it did not.

To measure the same amount of water at every test, a graduated microwave-safe glass jug is enough.

micro-ondes-ne-chauffe-plus-300x169 Microwave not heating: what to check before replacing it?

Pyrex Classic: 1 L glass measuring jug with lid

Graduated glass jug that goes in the microwave, freezer and dishwasher. It heats a measured volume of water, handy for testing the appliance.

micro-ondes-ne-chauffe-plus-1-1024x576 Microwave not heating: what to check before replacing it?
The glass-of-water test: the water either heated or it did not.

Tip: keep this test handy. You will repeat it after each solution to see whether the heat is back.

Solution 2: check the program, the time and the power level

  1. Check the selected program.
  2. Check the cooking time and the power level you set.
  3. Make sure you started a cooking cycle and not the kitchen timer (Kitchen Timer on some models), which counts down without heating.
  4. With auto or sensor cooking, add more food if the portion is small.

With a cooking cycle and a normal power level, the food should heat.

Good to know: with auto or sensor cooking, results vary from one dish to another. Food that comes out warm, even if less than you expected, needs no repair.

Solution 3: leave demo mode

Demo mode, also called display mode, is meant to show the appliance in a store. The microwave seems to work. It does not heat.

Advertisement
  1. Set a cooking time and start the appliance.
  2. Watch the timer: if it counts down much faster than normal, demo mode is on.
  3. On a Samsung with an Options or My Settings button, open option 6 and set it to 2.
  4. On other models, follow the procedure for leaving demo mode in the manual.

The timer should now count down at normal speed.

The key sequence depends on the model. According to an older Samsung manual, you had to press My Choice and then 9, which is not confirmed for current models. If your manual does not mention demo mode, contact customer support.

Solution 4: check the door and how it closes

A door that does not close completely can let the appliance run without heating.

  1. Wipe the door and its frame with a damp cloth to remove any debris.
  2. Remove stuck debris without forcing the latch hooks and without a sharp tool on the seals.
  3. Close the door firmly.
  4. Start a cycle and check that the light comes on and the plate turns.

With the door properly shut, repeat the glass-of-water test from solution 1.

Solution 5: check the socket and the ventilation

  1. Plug the microwave into another socket.
  2. Test the original socket with a small electrical appliance.
  3. Remove the extension lead if it is damaged, and stop using any socket that shows heat marks.
  4. Check the free space to the left, right, above and behind the appliance, using the distances given in the manual.
  5. For an over-the-range model that has never heated since it was installed, check the venting installation against the installation manual.

Too little space around the appliance restricts ventilation, and the heating becomes weak or stops altogether. Once the clearances are right, repeat the glass-of-water test. The water should heat.

micro-ondes-ne-chauffe-plus-2-1024x576 Microwave not heating: what to check before replacing it?
Another socket, some space around it, then the glass-of-water test.

If nothing works

Is the water still cold after all these checks? Stop there. Do not open the appliance: what comes next is a job for the manufacturer or an authorized repairer.

Contact the manufacturer’s customer service. For a Samsung model, use the support page for your country on the Samsung website. Have these ready:

  • the model number from the label;
  • a precise description of the symptoms: light, plate, timer, result of the glass-of-water test;
  • the purchase date, to know whether the appliance is still under warranty.

If the repair costs more than the appliance is worth, here are three microwaves to compare.

  • Samsung MS23K3513AK: 23 L solo microwave, 800 W, blackCountertop microwave with 23 litres of space, 800 W of power and button controls. A simple model for everyday reheating and defrosting.AmazonSee at Amazon
  • Sharp YC-MG01E-B: 20 L microwave with grill, 800 W20-litre microwave with a 1,000 W grill and manual controls. It reheats like a standard microwave and browns dishes under the grill.AmazonSee at Amazon
  • Panasonic NN-GT45KW: 31 L Inverter microwave with grill, 1,000 W31-litre microwave with grill and Inverter technology. It offers 24 automatic programmes and steadier heating.AmazonSee at Amazon

Another kitchen breakdown: see our guide on a fridge that no longer cools.

Take better care of your microwave: our toolbox

A few useful products to maintain the appliance and check how it heats.

  • HG: cleaner for microwaves and combination ovensCleaner that loosens grease and baked-on residue inside the cavity. Suitable for microwaves and combination ovens.AmazonSee at Amazon
  • Pyrex Classic: 1 L glass measuring jug with lidGraduated glass jug that goes in the microwave, freezer and dishwasher. It heats a measured volume of water, handy for testing the appliance.AmazonSee at Amazon
  • Etekcity infrared thermometer, non-contact reading from -50 to 610 °CReads the temperature of a surface or of the air from a vent without touching it. Handy to compare what the air conditioning blows before and after an adjustment.AmazonSee at Amazon

Frequently asked questions

Why does my microwave run but no longer heat?

Several causes can be checked without tools: demo mode on, the kitchen timer started instead of a cooking cycle, or a door that is not fully shut. Poor ventilation can also reduce or cut the heating. If all of those are fine, the fault may lie in an internal part such as the magnetron, the diode or the capacitor.

How do I test whether a microwave still heats?

Heat a microwave-safe glass of water on a short cycle in standard mode. If the water stays cold after a normal cycle, the appliance has a heating fault. Never run the test with nothing inside.

Can a microwave that no longer heats be repaired?

Yes, when the cause is a setting, demo mode, the door or the power supply: you can fix those yourself. A faulty magnetron, capacitor, diode or control board is repaired by a technician. Do not open the cover, because the capacitor can stay charged.

Can the microwave fuse stop it from heating?

Yes, the fuse is one of the internal parts that can be at fault when a microwave stops heating. Checking it means opening the appliance, which exposes you to the high-voltage capacitor. Leave it to a technician or to customer support.

Share this content:

Leave a Reply

Your email address will not be published. Required fields are marked *