This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.
Is your vacuum not picking up, losing suction, or cutting out and restarting? Bosch says to check the bag or dust bin first, then the filter. After that come the hose and wand, the brush bar and, on a cordless stick vacuum, the battery.
Each check takes a few minutes. Only a washed filter keeps you waiting longer: it needs 24 hours to dry.
Common symptoms and causes
- No suction at all: full bag or bin, clogged filter (so dirty it blocks the airflow), blockage in the wand, the hose or the brush inlet, dead battery or failed motor.
- Weak suction: dirty filter, brush bar wrapped in hair or thread, air leak in the hose, suction slider set to the low position on the cleaner head (Dyson High Torque XL).
- Cuts out and restarts, or pulses: on a Dyson, a blockage or a filter that is not seated properly (Blockage or Filter alert on the screen), or a low battery (the motor pulses three times).
Before you start
- Switch the vacuum off. Unplug a canister or upright from the wall socket, take a cordless stick off its charger or remove its battery.
- On a Dyson, never pull the trigger while you look for a blockage, while the bin is open or while the brush bar is out.
- Find the exact model on the machine: the way you take it apart varies by brand. The detailed steps follow the Dyson V10 manual; for any other model, its own manual takes priority.
- Watch out for sharp objects stuck inside. Carbon fiber brushes can slightly irritate skin, so wash your hands afterward.
Warning: never puncture, bend or heat a lithium battery, and work on a non-flammable surface. A swollen battery will not charge again and goes to a collection point. Never dry any part of the vacuum in an oven, a microwave or near a flame.
Warning: unplug the machine from the mains before opening it, and never work on a plugged-in appliance. The capacitors in some appliances (TVs, microwaves, power supplies) stay charged after unplugging, so do not touch them. A burning smell means you must stop using the vacuum immediately.
Warning: opening the machine can void the warranty, so check when it expires first. With Dyson, clearing a blockage is not covered by the warranty. Never take the motor apart.
Solution 1: empty the bin or change the bag
An overfull bag lets dust leak out and makes the motor strain, according to Rowenta. On a Dyson, a bin filled past the MAX mark pushes dirt back toward the filter. This is the most common fault.
- Check whether the bag or dust bin needs emptying.
- On a bagged vacuum, replace the bag if it is full or clogged.
- On a Dyson, hold the machine with the bin pointing down.
- Press the red bin release button firmly, all the way: the base only opens that way.
- If the bin is dirty, wipe it with a damp cloth, with no detergent and no trip through the dishwasher.
- Wait until the bin and its seals are dry.
- Close it by pushing the base up until it clicks.
If a full bin or bag was the problem, the vacuum gets its power back.
If your model takes bags, here are high-filtration Rowenta bags, only for models that accept them.

Rowenta ZR200520 Hygiene+: 4 high-filtration bags for bagged vacuums
These four-layer bags hold back fine dust. A fresh bag gives a bagged vacuum its full suction back.
- AmazonSee at Amazon
Tip: Rowenta advises emptying the bin after every use, without waiting for it to fill.
Solution 2: clean or replace the filters
In Bosch’s order, the filter comes right after the bag. On a Dyson V10, the Filter alert on the screen means the filter is badly seated or needs cleaning.
Warning: Dyson forbids putting its parts in the dishwasher, the washing machine or the tumble dryer. Wash the filter by hand.
- Take the filter out by turning it counterclockwise.
- Tap it gently to knock the dust out.
- Wash it by hand in cold water only: the pleated paper first, then the foam, held facing down.
- Rinse until the water runs clear.
- Gently squeeze the foam to wring it out.
- Dry the foam filter facing up, in a dry, airy place, for at least 24 hours.
- Once it is completely dry, put it back by turning it clockwise until it clicks.
The filter is clean, dry and clicked into place.

Dyson asks for this wash at least once a month, or when the machine tells you to, and more often with fine dust or in boost mode. With Rowenta, a washable filter is rinsed in lukewarm water and left to dry completely before it goes back in, while a non-washable filter is replaced periodically.
Good to know: the water is cold for Dyson and lukewarm for Rowenta, so follow your model’s manual. For a non-washable filter, an interval of 6 months to a year circulates, but we could not verify it in a manual.
If the filter is still clogged after washing and you have a Dyson V10, here is the original filter.

Dyson: genuine washable filter for V10 vacuums (part 969082-01)
This washable filter catches fine dust before it reaches the motor. Replace it when it stays clogged even after washing.
- AmazonSee at Amazon
Solution 3: clear the wand, the hose and the brush inlet
A Dyson can switch itself off when something blocks it, thanks to its automatic cut-out. The motor vibrates and the screen points to the blockage.
- On a Dyson V10, pull the wand off the handle using its red release button.
- Look for a blockage in the cleaner head, the telescopic wand and the hose.
- Push a broom handle through the telescopic wand or the hose to dislodge the blockage.
- Inspect the hose and the wand for cracks, kinks and air leaks at the joints.
- On a Dyson, remove the clear bin and clear any obstruction from the main body.
- If the blockage in the head is out of reach, release the brush bar with a coin, then slide it out of the head.
- Put the brush bar back and tighten it firmly.
Air now passes freely from the head to the body of the machine.
Tip: point a lamp or look toward a window through the detached wand. A blockage shows up right away.
Solution 4: clean the brush bar
The brush bar has to spin freely, Rowenta reminds us. Hair and thread eventually slow it down. Steps 1 to 3 and 5 to 9 follow the manual for the Dyson High Torque XL head.
- Unplug the vacuum from the charger.
- Pull the red tab on the head and take out the brush bar.
- Turn the end cap of the brush bar and remove it, without washing it.
- Remove the hair, thread and debris wrapped around it.
- Rinse the brush bar under cold water, rubbing gently, with no detergent.
- Stand it upright to dry: it must be completely dry before it goes back in.
- Wipe the housing of the head with a damp, lint-free cloth, without washing it.
- Put the brush bar back in the head and tighten it firmly.
- Set the suction slider on the head to
+.
The brush bar now spins freely. Do not wash the Dyson mini motorized tool.
The - position of the slider reduces suction. Dyson reserves it for thick rugs and delicate floors.
Solution 5: a stick vacuum that pulses or cuts out
A Dyson’s motor pulses to signal a problem, and the screen shows the cause.
- Look at the screen: three motor pulses with an icon on the screen call for a recharge, and a red warning icon means the battery is empty.
- If the screen shows the Filter alert, reseat the filter or clean it (Solution 2).
- If the screen reports a blockage, go back to Solution 3.
- Charge the vacuum until it is full: the charge time listed for the V10 is 4.5 hours.
- Check the end of charging: the blue LEDs, which flash while charging, stay lit for 5 seconds and the screen shows 100%.
- Switch from Boost mode to Eco or Auto (Auto with the High Torque XL head).
- If you have a spare clip-on battery, remove the empty one with its release button and slide the other in until it clicks.
The motor now runs continuously, without pulsing.

Boost mode cuts the run time: Dyson recommends Eco or the intermediate mode for everyday use.
Good to know: below 0 °C (32 °F), a Dyson will not run, to protect the motor and the battery. A stick vacuum left in a cold garage only starts once it is back at room temperature.
On a cordless Rowenta, a battery that no longer holds its charge should go to a professional. For a robot vacuum, see our guide Roomba won’t charge anymore.
If nothing works
Bag, filters, wand, hose, brush bar and battery checked with no result? Suspect the motor, the battery or the drive belt. Stop there if the motor will not start, makes an unusual noise or gives off a burning smell, a possible sign of overheating.
A grinding or whistling sound points to an internal blockage, according to Rowenta. Contact the brand’s support with the exact reference of the machine:
- Bosch: phone support in France Monday to Friday, 8:30 am to 12 pm and 2 pm to 5:30 pm, on
0 892 698 010(0.40 €/min plus the cost of the call), or through the Contact us link of the Bosch online help. Outside France, use your local Bosch support page. - Rowenta: 2-year warranty, a stated 15 years of repairability, approved repairers, repair packages and, in France, the QualiRépar bonus (consumables excluded).
- Dyson: go through Dyson support; clearing a blockage remains outside the warranty.
To replace the machine, our comparison Roborock vs Dreame: which robot vacuum to choose may help.
If the repair costs more than the machine is worth, here are three cordless stick vacuums from established brands to compare.
- Dyson V8 Advanced: cordless stick vacuumCordless stick vacuum with 130 AW suction and up to 40 minutes of battery life. Its anti-tangle brush suits hard floors and rugs.AmazonSee at Amazon
- Rowenta X-Force Flex 9.60: cordless stick vacuum with flexible tubeCordless stick vacuum whose flexible tube reaches under low furniture. Digital display and removable battery.AmazonSee at Amazon
- Bosch Unlimited 8 BBS8214: cordless stick vacuum with interchangeable batteryCordless stick vacuum with a battery you swap without tools. Large dust container and fine filter.AmazonSee at Amazon
Take better care of your vacuum cleaner: our toolbox
A few simple accessories to keep your suction strong from one clean to the next.
- Dyson: genuine washable filter for V10 vacuums (part 969082-01)This washable filter catches fine dust before it reaches the motor. Replace it when it stays clogged even after washing.AmazonSee at Amazon
- Rowenta ZR200520 Hygiene+: 4 high-filtration bags for bagged vacuumsThese four-layer bags hold back fine dust. A fresh bag gives a bagged vacuum its full suction back.AmazonSee at Amazon
- Sanggi: long flexible brush for condenser and radiatorLong, thin brush that reaches dust between fins and grilles. Use it with the appliance switched off.AmazonSee at Amazon
- Vileda Colors: 8 microfibre clothsEight reusable microfibre cloths that pick up dust without scratching. Handy for wiping plastic parts and dust containers.AmazonSee at Amazon
Frequently asked questions
Why is my vacuum not sucking anything up?
A full bag or bin, a clogged filter or a blockage in the wand, the hose or the brush bar are the first causes to check. Go through them in that order, as Bosch advises. On a cordless stick vacuum, a dead battery also cuts the suction.
How do you unclog a vacuum cleaner?
Unplug the machine, then look for the blockage in the brush bar, the wand and the hose. Bosch advises pushing a broom handle through them. On a Dyson, also remove the bin and, if needed, the brush bar from the head.
Should you wash a vacuum cleaner filter?
Yes, if it is washable: Dyson asks for a wash at least once a month, in cold water, followed by 24 hours of drying. Rowenta recommends lukewarm water and complete drying. A non-washable filter is replaced periodically.
Why does my Dyson vacuum cut out and restart (pulse)?
The motor pulses to signal a blockage, a badly seated filter or a low battery. Three pulses with an icon on the screen call for a recharge. Read the alert on the screen, then follow the matching solution.
When should you replace the battery of a stick vacuum?
When it no longer holds its charge. Rowenta then advises consulting a professional. A swollen battery will not charge again and goes to a collection point.
Share this content:
