This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.
Is your cigarette lighter socket not working, leaving the charger, GPS or air compressor plugged into it dead? Check the accessory first, then look for an object that fell into the socket and test the fuse, the small part that cuts the circuit when it is overloaded.
Common symptoms and causes
- The accessory stays off in every socket: faulty charger, cable or USB adapter.
- The socket gives nothing with the engine off: on some vehicles it is only powered with the key in the accessory position or the ignition on.
- The socket went dead after a coin or paperclip fell in: the metal object shorted it and blew the fuse.
- The socket quit when you plugged in a power-hungry device: fuse blown by overload.
- Paper, crumbs or residue at the bottom of the socket: poor contact.
- Fuse is fine but there is still no power: faulty wiring or socket.
Before you start
Turn the ignition off before inspecting the socket or the fuse box. Do not touch the airbags, the seat belt pretensioners or the high-voltage circuit of a hybrid or electric vehicle. A red warning light on the dashboard means you should stop driving, and this procedure does not replace a diagnosis at a workshop.
Warning: never replace a fuse with a higher-rated one, and never push a metal object into a live socket. The risk is a short circuit and overheated wiring. Before any work on the wiring, disconnect the negative battery terminal.
Replacing the socket or working on the wiring may be a job for a garage and can affect the vehicle warranty: check when your warranty ends before you start.
Get ready:
- the vehicle owner’s manual, for the fuse location and rating (its amperage, in amps
A); - a spare fuse of the same rating and a fuse puller;
- a multimeter, the tool that measures voltage, if you go as far as solution 4.
Solution 1: test the accessory and the socket’s power
- Turn the ignition on, or the key to the accessory position, before deciding the socket is dead.
- Plug the accessory into another 12 V socket in the vehicle.
- Try a different cable or a different USB adapter with the same device.
- Plug an accessory you know works into the suspect socket.
If the other accessory works in the socket, the culprit is your charger, its cable or its adapter. If it stays off too, go to solution 2.

Good to know: the official manuals we checked do not say which key position powers the socket. That detail comes from an accessory maker.
With the engine off, go easy on the battery. According to a copy of its manual, Toyota advises against prolonged use with the engine off so the battery does not drain; Renault asks, for the Trafic, that you unplug all devices when leaving the vehicle.
Solution 2: inspect and clean the socket
Ignition off, always.
- Bring your hand close carefully: the socket may be hot.
- Shine a light into the socket and look for a coin, a paperclip, paper or residue.
- Remove the object or residue without putting any metal object into the socket.
- If a metal object was in the socket, go straight to the fuse check in solution 3: it may have shorted the socket and blown the fuse.
The socket should be empty and clean. Plug an accessory back in and turn the ignition on to test it again.
Tip: according to a copy of the 2011 Toyota Sienna manual, keeping the socket cover closed when you are not using it stops an object or liquid from falling in and causing a short circuit.
Solution 3: check and replace the cigarette lighter fuse
Turn the ignition off before opening the fuse box.
- Look in the owner’s manual for the fuse box location, the label of the socket’s fuse and its rating.
- Open the fuse box and find the fuse using the diagram on the back of the cover or the table in the manual.
- Pull the fuse out with the fuse puller.
- Look at the metal strip inside the fuse: if it is broken, the fuse is blown.
- Identify the cause before replacing it: an object that fell into the socket, or an accessory that draws too much power.
- Replace it with a fuse of the same amperage, which means the same color.
- If the vehicle has several sockets (front, rear, trunk), check their fuses too.
The plugged-in accessory should light up as soon as you turn the ignition on. Spare fuses are often kept in the box itself.
Good to know: the location and rating change from one model to the next. On a Ford Mondeo, owners found a 15 A fuse under the steering wheel; on a Renault Espace IV, two 15 A fuses (no. 20 and 22) behind a flap to the left of the steering wheel. The Peugeot Bipper manual lists F96 (12 V accessory socket) and F94 (cigarette lighter), both 15 A: these are examples, and your own vehicle’s manual is the reference.
If the fuse is blown, here is an assortment of spare fuses with a puller and a tester.

Assortment of 306 car fuses, standard and mini blade, with puller and tester
A box of spare blade fuses in the common ratings, with a puller and a tester to check them. Handy to keep in the glove box.
- AmazonSee at Amazon
On the Espace IV, a console fuse that tested fine did not rule out another blown fuse, hence step 7. For other equipment, the same method works to check the fuse of a windshield wiper that has stopped working.
Solution 4: fuse is fine but the socket is dead, or the fuse blows again
- Compare the accessory’s power draw with the limit given in the vehicle’s manual, without relying on a universal value.
- Set the multimeter to DC voltage (
DC). - Turn the ignition to the accessory position.
- Place the red probe on the center of the socket.
- Place the black probe on the metal wall of the socket, making sure the two probes do not touch.
- Read the value: less than
12 V, or no voltage at all, points to faulty wiring or a faulty socket. - If a new fuse blows right away, do not replace it again: the fault, a short circuit, is still there.
A healthy socket reads at least 12 V. If not, the problem is behind the socket.
If you do not have a multimeter, here is an easy-to-use one for this measurement.

AstroAI digital multimeter, 2000 counts
Measures DC and AC voltage, current and continuity. Lets you check whether a socket or a fuse really delivers power.
- AmazonSee at Amazon

Warning: the limit varies by model. Renault states 120 W per accessory and 180 W in total on the Trafic, with a fire risk beyond that; Peugeot gives 180 W for the Bipper’s 12 V socket. A device that draws too much blows the fuse by overload.
If nothing works
Stop if the fuse is fine but the socket delivers no voltage, or if a new fuse blows again after replacement. The short circuit, the ground, the positive cable or the socket itself then become a job for a garage or an auto electrician: tracing the wiring means removing trim panels and disconnecting the battery. Peugeot recommends having the electrical system checked by its network or a workshop if the fault comes back soon after the replacement.
For the garage, bring the manual and note the number of the fuse you checked and the voltage you measured. If the socket has to be replaced, there are models with USB ports, with a cover or with a built-in voltmeter. For a vehicle under warranty, check the warranty terms before having the socket replaced.
Prolonged use with the engine off can drain the battery. If that happened, see what to do when your car battery is dead.
Look after your 12 V socket: our toolbox
A few products to look after the socket and what you plug into it.
- Assortment of 306 car fuses, standard and mini blade, with puller and testerA box of spare blade fuses in the common ratings, with a puller and a tester to check them. Handy to keep in the glove box.AmazonSee at Amazon
- AstroAI digital multimeter, 2000 countsMeasures DC and AC voltage, current and continuity. Lets you check whether a socket or a fuse really delivers power.AmazonSee at Amazon
- Anker 30 W car charger, USB-C and USB-APlugs into the 12 V socket and charges a phone and a second device at once. A good replacement when the old charger has failed.AmazonSee at Amazon
- LENCENT Bluetooth 5.0 FM transmitter for the car socket, with charging portsPlays music from a phone through the car radio and charges devices from the 12 V socket. Useful to get more from a working socket.AmazonSee at Amazon
Frequently asked questions
Why is my cigarette lighter socket not working?
The most common causes are a faulty accessory, cable or adapter, an object that fell into the socket and a blown fuse. The fuse blows from overload or when a metal object shorts the socket. Less often, the wiring or the socket itself is at fault.
Where is the cigarette lighter fuse?
Its location depends on the model: the vehicle’s manual and the diagram on the back of the fuse box cover show it. In the examples we found, it is on the driver’s side: under the steering wheel (Ford Mondeo), behind a flap to the left of the steering wheel (Renault Espace IV) or in the dashboard box (Peugeot Bipper). The Bipper also has a second box under the hood.
What should I do if the cigarette lighter is not working but the fuse is fine?
Check the fuses of the other sockets, since each socket can depend on a different fuse. Then measure the voltage with a multimeter, with the ignition in the accessory position. Less than 12 V or nothing at all points to faulty wiring or a faulty socket, which a garage should diagnose.
How much power can you plug into a cigarette lighter socket?
Your vehicle’s manual gives the limit, and it varies from one model to another. Renault states 120 W per accessory on the Trafic, Peugeot 180 W on the Bipper, and a copy of the 2011 Toyota Sienna manual gives 10 A at 12 V. Beyond that, the fuse can blow.
Does the cigarette lighter work with the ignition off?
It depends on the vehicle: according to an accessory maker, some sockets are only powered with the key in the accessory position or the ignition on. The official manuals we checked do not say. Renault advises unplugging devices when leaving the vehicle so the battery does not drain.
Share this content:
