This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.
A dead car battery stops the engine from starting, and most of the time a set of jumper cables and a second car fix it. Carmakers name three causes: headlights or a dome light left on while parked, heavy electrical load while driving, or a worn-out battery. Allow about 30 minutes, including the jump-start and the drive that recharges the battery.
Common symptoms and causes
- The engine won’t start after the headlights or a dome light were left on: the battery drained fast while the car sat parked.
- The battery ran down gradually because of heavy electrical load while the car was running.
- Starting problems keep coming back: the battery may be worn out.
- The car was jump-started, then switched off too soon, so it may not restart.
Before you start
You need a donor car with a 12 V battery, jumper cables and your vehicle’s manual. The manual shows the jump-start points and the ground point: the spot the manufacturer provides for the black clamp, bare fixed metal, away from the battery.
Warning: switch off the ignition in both cars. Do not touch the airbags, the seat belt pretensioners or the high-voltage system of a hybrid or electric vehicle. A red warning light means you must stop the vehicle, and this procedure is no substitute for a diagnosis in a workshop.
Warning: a lead-acid battery gives off hydrogen, an explosive gas. No flame, no cigarette, no spark near the battery, and wear safety glasses: the acid is corrosive and toxic. Do not lean over the battery and never check the electrolyte level (the liquid inside it).
Warning: never jump-start a frozen battery or one with a low electrolyte level. Never put the black clamp on the dead battery, as a spark can occur there. The + and − clamps must never touch each other.
Warning: on a Start & Stop car, the black clamp does not go on the battery terminal. It goes on the ground point provided in the engine bay, otherwise the battery sensor can be damaged.
Some hybrids and electric cars cannot serve as the donor car. The 12 V battery of an electric car can generally receive a jump, but must not give one. Check the manual.
Also check these points:
- Both systems must be 12 V: a 24 V source damages the starter and the ignition.
- The two cars must not touch each other.
- The cables have fully insulated clamps, are at least 2 m (about 6.5 ft) long and have a cross-section of at least 25 mm² (
DIN 72553orISO 6722standards). A diesel draws more current when starting: use thicker cables and a well-charged donor car.
Good to know: a jump starter (a portable starting battery) replaces the donor car. We have no verified manufacturer procedure for these devices, so follow the instructions that came with yours.
Solution 1: jump-start with cables and another car
Kia manuals and the ADAC (the German automobile club) give the same connection order.
- Switch off unnecessary electrical loads in both cars.
- Attach one red clamp to the + terminal of the dead battery.
- Attach the other red clamp to the + terminal of the donor battery.
- Attach one black clamp to the − terminal of the donor battery, or to its ground point.
- Attach the other black clamp to the ground point of the broken-down car, or to a piece of bare, fixed metal on the engine block, away from the battery and moving parts.
- Start the donor car and let it run for a few minutes.
- Start the engine of the broken-down car with a short attempt.
- If it fails, wait 1 minute before trying again.
The engine of the broken-down car must keep running on its own. The Kia manual says to hold the donor car at about 2000 rpm; the ADAC gives no engine speed.

Tip: before connecting anything, look at the terminals of the dead battery. A terminal that moves by hand or is covered in a whitish deposit passes current poorly, even with good cables.
Warning: after the third failed attempt, switch off the ignition in both cars and stop trying. Call roadside assistance.
Once the engine is running, disconnect in this order:
- Turn on the heater (fan) and the headlights of the jumped car: at this stage it is intended, as these loads prevent voltage spikes when you disconnect.
- Remove the black clamp from the jumped car.
- Remove the black clamp from the donor car.
- Remove the red clamps.
- Leave the engine running and turn off the heater and headlights.
The cables are put away and the engine of the jumped car is still running.
Do you only have short or thin cables? Here is a heavy-gauge pair worth keeping in the trunk.

GYS 1000 A jump leads, 50 mm², 4.5 m, brass clamps
Carry current from a donor car to a flat battery. Their thick section also suits large diesel engines.
- AmazonSee at Amazon
Solution 2: recharge a dead car battery by driving
- Keep the engine running after the jump-start.
- Drive for at least 30 minutes, or let the engine idle for at least 60 minutes, as the Hyundai manual states.
- Watch the dashboard warning lights during the drive.
- Prefer one long drive with few stops.
The car should restart normally at your next stop.
Warning: right after a jump-start, the power steering may fail, according to the ADAC. Drive carefully. Stop if a warning light comes on.
Tip: don’t switch the engine off for a quick errand right after the jump. That is the classic case of a car that won’t restart ten minutes later.
Solution 3: recharge with a battery charger
The ADAC recommends a suitable charger or long drives with few stops; a small charger left connected overnight is fine. The times and currents in steps 4 and 5 come from the Hyundai manual, for its maintenance-free calcium battery. For an AGM or EFB battery, follow the instructions of the charger and the battery.
- Put the car in a ventilated place.
- For an AGM battery (an absorbed glass mat battery), choose a fully automatic charger designed for AGM.
- Connect the charger to the battery following its instructions.
- After lights left on, charge at a slow rate for about 10 hours.
- After a gradual discharge from heavy load while driving, charge at 20 to 30 A for about 2 hours; this current does not apply to an AGM battery.
- Reduce or stop charging if the battery cells start to bubble.
- Unplug the charger from the mains.
- Remove the negative clamp, then the positive clamp.
The charged battery should start the engine without help.

Warning: never open the top cap of an AGM battery.
If you don’t own a charger, here is an automatic 12 V charger that can stay connected to maintain the battery.

CTEK MXS 5.0 12 V battery charger with temperature compensation
Recharges a car battery slowly and automatically, and adjusts the charge to the outside temperature. Can stay connected to maintain the battery.
- AmazonSee at Amazon
Solution 4: have the battery tested or replaced
- Note whether starting problems come back after a recharge: a worn-out battery is one possible cause.
- Have a garage check the electrical system if the cause of the discharge remains unknown.
- Leave the replacement of an AGM battery to a professional workshop.
The car starts again without help, day after day.
Good to know: a roadside assistance patrol, like those of the ADAC, can test the battery and replace it on the spot.
If nothing works
Stop after three failed start attempts, if a fault appears while driving, or if you don’t know where to attach the clamps. Call your insurance’s roadside assistance or a tow service, or have the car towed to a garage.
Have the vehicle’s model and year at hand, the battery type (conventional, EFB or AGM, printed on its label), its purchase date and what you have already tried.
If only the key fob remote has stopped responding, see replacing the battery in a Renault key fob. If the car starts but the screen stays blank with your phone, see Apple CarPlay not working in the car.
Take better care of your car battery: our toolbox
These accessories help you restart, recharge and check a 12 V battery before the next breakdown.
- NOCO Boost GB40 1000 A jump starterStarts an engine whose battery is too weak, without a second car. It also works as a power bank to charge a phone.AmazonSee at Amazon
- CTEK MXS 5.0 12 V battery charger with temperature compensationRecharges a car battery slowly and automatically, and adjusts the charge to the outside temperature. Can stay connected to maintain the battery.AmazonSee at Amazon
- GYS 1000 A jump leads, 50 mm², 4.5 m, brass clampsCarry current from a donor car to a flat battery. Their thick section also suits large diesel engines.AmazonSee at Amazon
- AstroAI digital multimeter, 2000 countsMeasures DC and AC voltage, current and continuity. Lets you check whether a socket or a fuse really delivers power.AmazonSee at Amazon
Frequently asked questions
How do you jump-start a car with a dead battery?
With jumper cables and a 12 V donor car: red on the + of the dead battery, then on the + of the donor. Then attach black to the − of the donor, then to the ground point of the broken-down car, never to its battery. When disconnecting, remove the black clamps in reverse order, then the red ones.
How long does it take to recharge a dead car battery?
The Hyundai manual says at least 30 minutes of driving, or 60 minutes of idling, after a jump-start. On a charger, it allows about 10 hours at a slow rate after lights left on. For a full recharge, the ADAC recommends a charger or long drives with few stops.
Dead car battery in freezing weather: what to do?
First check that the battery isn’t frozen: a frozen battery must never be jump-started. If it is, call roadside assistance or a garage. Otherwise, the jump-start procedure and the recharge stay the same.
Why does my car battery drain for no reason?
If you can’t find the cause, have a garage check the electrical system. The causes carmakers cite are headlights or a dome light left on, heavy load while driving and a worn-out battery.
When should you replace a car battery?
When starting problems keep coming back, the battery may be worn out. A garage or a roadside patrol can test it and replace it. An AGM battery is replaced in a professional workshop.
Share this content:
