Advertisement
Home appliances and smart home

Freezer Not Cooling? What to Check Before You Call for Repair

Temperature climbing or alarm sounding? Check the setting, seal, ventilation and frost in order, then call the service center if the temperature stays above -18 °C.

6 min read

Freezer under a crossed-out snowflake with a warning sign and a diagnostic magnifying glass
Table of contents
  1. Common symptoms and causes
  2. Before you start
  3. Solution 1: check the power and the thermostat setting
  4. Solution 2: read the alarm and allow time after a big load
  5. Solution 3: check the door and the seal
  6. Solution 4: free up the appliance and clean the ventilation
  7. Solution 5: fully defrost the freezer
  8. If nothing works
  9. Take better care of your freezer: our toolbox
  10. Frequently asked questions
    1. Why is my freezer not cooling anymore?
    2. What temperature should a freezer show?
    3. Can you refreeze thawed food?
    4. When should you defrost a freezer?

This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.

Your freezer is not cooling: the displayed temperature keeps climbing or the alarm is sounding. Before assuming a breakdown, check the power, the setting, the door, the ventilation and the frost, in that order.

Advertisement

This guide covers an upright or chest freezer that has stopped making cold, and the freezer section of a fridge-freezer. For the fridge compartment, see our guide on a fridge that is not cooling.

Common symptoms and causes

  • Temperature set too high, or changed by mistake
  • Too much fresh or warm food loaded at once
  • Door or lid not fully closed, dirty or damaged seal, warped door
  • Thick frost or ice on the walls
  • Dusty condenser or ventilation grille, appliance pushed against the wall
  • Appliance next to a heat source, or a room outside the range of its climate class (a cold garage in winter, for example)
  • Faulty thermostat or temperature sensor
  • Appliance failure (code F4 or F5 on some Liebherr chest freezers); Bosch also lists a faulty compressor or sensor

Before you start

Get ready:

  • a freezer thermometer, to check the real temperature;
  • the appliance’s rating plate, which gives the climate class and the numbers the service center asks for;
  • a cooler, or some room in the fridge, to keep the food safe.

Warning: unplug the appliance from the mains before opening it; never work on a plugged-in appliance; the capacitors of some appliances (TVs, microwaves, power supplies) stay charged after unplugging, so do not touch them. Unplug before any cleaning or defrosting too, and keep water away from the electrical parts.

Warning: a breakdown or a defrost can cost you food. At -18 °C, micro-organisms barely grow, but thawed food becomes highly perishable and any break in the cold chain lets micro-organisms multiply. If your food is at risk, Bosch advises moving it to the fridge, to a neighbor’s or into a cooler, because warming exposes it to salmonella.

Tip: to find out whether the cold chain was broken, put a half-filled bottle of water in the freezer; once the water has frozen, turn the bottle upside down. If the ice has moved down, even partly, the contents have thawed.

Warning: opening the appliance may void the warranty, so check the warranty end date first. With Liebherr, a service visit caused by an operating error is charged even under warranty: run the checks below before you call.

Advertisement

Solution 1: check the power and the thermostat setting

The thermostat is the control that sets the target temperature, called the set point.

  1. Check whether the indicator lights on the control panel are on.
  2. If everything is off, make sure the plug is pushed firmly into the outlet.
  3. Check that the outlet’s fuse is in good condition.
  4. Read the displayed temperature: it is the warmest temperature among the frozen products.
  5. On a Liebherr chest freezer, press the Down button to lower the set point or the Up button to raise it, in steps of 1 °C.
  6. Set the temperature to -18 °C, the factory value of these chest freezers and the temperature recommended by the French Ministry of Agriculture.
  7. Wait about 5 seconds without touching the buttons.
  8. To test the thermostat as Bosch suggests, unplug the appliance, then plug it back in.
congelateur-ne-refroidit-plus-1-1024x576 Freezer Not Cooling? What to Check Before You Call for Repair
Check the plug, then set the temperature to -18 °C.

Expected result: the value you set flashes while you adjust it, then the display goes back to the real temperature.

If the thermostat is faulty, Bosch sells the replacement part.

On other brands the buttons have different names: follow your appliance’s manual.

Solution 2: read the alarm and allow time after a big load

Good to know: the display climbs for a while after every opening and every load of fresh food. A high reading right after grocery shopping does not necessarily mean a fault.

  1. If the alarm sounds and the display flashes, press the ALARM button to silence it (Liebherr chest freezer).
  2. Check that the lid is properly closed: the door alarm goes off if it stays open for more than about 60 seconds.
  3. If you put a lot of fresh food in at once, check the display again 24 hours later.
  4. Place a thermometer inside the appliance to check the real temperature.
  5. Before the next big load, press the SuperFrost button (Liebherr chest freezer): its indicator light comes on.
  6. Wait about 6 hours for a small quantity, or about 24 hours for a large one, before adding the fresh food.

Expected result: the display stops flashing at around -14 °C.

Advertisement

SuperFrost switches off by itself after 30 hours (65 hours at most). You can turn it off with another press once the temperature has dropped below -18 °C.

Warning: on a Liebherr chest freezer, an F4 or F5 reading signals a fault. The safety function keeps the temperature under control, but the appliance has to be seen by the service center: go straight to the “If nothing works” section.

To check the real temperature without relying on the display, here is a thermometer that sits inside the appliance.

congelateur-ne-refroidit-plus-300x169 Freezer Not Cooling? What to Check Before You Call for Repair

Xavax Hama analogue thermometer for fridge and freezer

A hanging thermometer graduated from -35 to 40 °C. It lets you check the temperature without relying on the appliance display.

Solution 3: check the door and the seal

The seal is the soft gasket that closes the door or lid tightly. Bosch requires it to sit firmly against the cabinet.

  1. Open the door or lid and inspect the seal for damage or dirt.
  2. Unplug the appliance before cleaning the seal.
  3. Remove the dirt from the seal.
  4. Close it again and check that the seal sits firmly.
  5. Look to see whether the door is warped.
  6. Replace the seal or the door if they are faulty.

Expected result: the seal is clean, intact and sits firmly. Then plug the appliance back in.

Solution 4: free up the appliance and clean the ventilation

The condenser is the coil at the back of many appliances. According to Bosch, dust or contact with the wall makes cooling harder.

  1. Move the freezer away from the oven, hobs and any other heat source.
  2. Keep it out of the sun and away from heating, too.
  3. Unplug the appliance before touching the condenser or the grilles.
  4. Pull the appliance away from the wall so air can circulate.
  5. Clean the dust off the condenser at the back.
  6. On a Liebherr chest freezer, clean the ventilation grilles.
  7. Leave at least 20 cm between the unit’s ventilation grille and the wall, without blocking the space under the appliance.
  8. Read the climate class on the rating plate, on the outside of the appliance.
  9. Compare it with the room temperature, using the table below.
Climate classRoom temperature
SN+10 to +32 °C
N+16 to +32 °C
ST+16 to +38 °C
T+16 to +43 °C

These ranges come from the manual of a Liebherr chest freezer. Other Liebherr manuals give +18 °C as the lower limit for classes N, ST and T: the plate on your appliance is the reference.

Expected result: the appliance is away from any heat source, air flows behind it and the room stays within the range of its climate class. Then plug it back in.

To dislodge the dust behind the appliance, a long, soft brush reaches the condenser.

congelateur-ne-refroidit-plus-300x169 Freezer Not Cooling? What to Check Before You Call for Repair

Sanggi: long flexible brush for condenser and radiator

Long, thin brush that reaches dust between fins and grilles. Use it with the appliance switched off.

Solution 5: fully defrost the freezer

According to Bosch, thick frost on the walls hinders cooling. Warning: defrosting means emptying the appliance; make room for your food before you start, or it may thaw.

  1. The day before, turn on the SuperFrost function to build up a cold reserve (Liebherr chest freezer).
  2. On the day, switch the appliance off with the ON/OFF button (Liebherr chest freezer).
  3. Unplug it.
  4. Empty the appliance.
  5. Leave the food in its baskets, wrap it in newspaper or blankets and put it somewhere cool.
  6. Remove the drain plug.
  7. Place the dividing partition under the appliance to channel the water.
  8. Leave the lid open while the ice melts.
  9. Mop up the meltwater.
  10. Clean the inside with lukewarm water and dish soap, with no abrasives or steam cleaner, taking care not to wet the electrical parts and the ventilation grille.
  11. Wait a few hours before plugging back in, as Bosch asks.
congelateur-ne-refroidit-plus-2-1024x576 Freezer Not Cooling? What to Check Before You Call for Repair
Appliance off and unplugged, lid open: let the ice melt, then mop up.

Expected result: the walls are clean and free of ice.

Warning: Liebherr advises against using any mechanical tool to chip the ice off, or any artificial defrosting method the manufacturer does not recommend.

Bosch does not give a figure for the wait before plugging back in.

If nothing works

Call a technician if, after the setting, seal, ventilation and defrost checks, the temperature stays above -18 °C. If none of the checks helped, Bosch says the compressor or the temperature sensor may be faulty: unplug the appliance and book a technician.

An F4 or F5 code on a Liebherr chest freezer also signals a fault: call the service center.

Contact the brand’s service center. For Bosch in France, the hotline answers on 0 892 698 010 (0.40 € per minute plus the cost of the call).

Have these to hand:

  • the appliance designation and its index;
  • the service number and the appliance number, printed on the rating plate;
  • the displayed code, if there is one.

For another kitchen appliance, see also our guide on a microwave that no longer heats.

Take better care of your freezer: our toolbox

These accessories help you monitor the temperature, keep the condenser clean and protect your food during an outage.

  • Xavax Hama analogue thermometer for fridge and freezerA hanging thermometer graduated from -35 to 40 °C. It lets you check the temperature without relying on the appliance display.AmazonSee at Amazon
  • Sanggi: long flexible brush for condenser and radiatorLong, thin brush that reaches dust between fins and grilles. Use it with the appliance switched off.AmazonSee at Amazon
  • Dometic Cool-Ice WCI 33: 33 litre passive cool boxAn insulated cool box with thick walls, to be used with ice packs. It keeps food cool during a breakdown or a defrost.AmazonSee at Amazon
  • TFA Dostmann 95.1034: set of 2 analogue fridge thermometersTwo thermometers to place or hang, with marked cooling zones. They let you check the real temperature of the fridge and the freezer.AmazonSee at Amazon

Frequently asked questions

Why is my freezer not cooling anymore?

Check first for a temperature set too high, a door that is not fully closed, a dirty or damaged seal and thick frost on the walls. A big load of fresh food, a dusty condenser, an appliance pushed against the wall or next to a heat source also play a part. If none of this explains the problem, Bosch points to a faulty compressor or temperature sensor.

What temperature should a freezer show?

A freezer should be set to -18 °C, the temperature recommended by the French Ministry of Agriculture and the factory set point of Liebherr chest freezers. At that temperature, micro-organisms barely grow. The display shows the warmest temperature among the products and climbs for a while after an opening or a load: a thermometer placed inside the appliance gives the real temperature.

Can you refreeze thawed food?

Raw food that has thawed must never be refrozen. The French Ministry of Agriculture allows refreezing only for cooked products, and Liebherr accepts it for a prepared dish that has not stayed too long at room temperature. A product you do not reheat, such as a cream cake or an ice cream, must not stay out of the cold for more than 2 hours; for vegetables and bread, the risk is almost nil.

When should you defrost a freezer?

Defrost it as soon as a layer of ice forms on the walls, as Liebherr recommends. A layer that is too thick raises electricity consumption, and Bosch points out that thick frost hinders cooling.

Share this content:

Leave a Reply

Your email address will not be published. Required fields are marked *