Advertisement
Cars

Power window not working: what can you check yourself first?

A failed power window can first be checked without tools: rear-window lockout, reset after a battery disconnect, and the fuse. Beyond that, the motor or mechanism is a workshop job.

5 min read

Car with a warning sign, a diagnostic magnifying glass and a flat wrench
Table of contents
  1. Common symptoms and causes
  2. Before you start
  3. Solution 1: check the rear-window lockout
  4. Solution 2: reset the window after the battery was disconnected (Peugeot 208 and 508)
  5. Solution 3: check the power window fuse
  6. If nothing works
  7. Take better care of your car: our toolbox
  8. Frequently asked questions
    1. Why is my power window not working?
    2. What should I do if the power window button stops working?
    3. Where is the power window fuse?
    4. How do I reset a power window after changing the battery?

This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.

When a power window stops working, three things are worth checking yourself before you call a garage: the rear-window lockout, the anti-pinch reset after the battery was disconnected, and the fuse. Go through them in that order, simplest first.

Advertisement

Taking the door apart is a job for a workshop.

Common symptoms and causes

  • The rear windows do not respond: the driver may have disabled their controls, or the fuse of the child safety relay is at fault.
  • After the battery was disconnected, the window only rises in jerks of a few centimeters: the anti-pinch function needs to be reset (a case described in the Peugeot 208 and 508 handbooks).
  • No window works, or a single switch no longer responds: check the fuse, then have the switch and the motor tested.
  • The window ignores every check: the motor, the mechanism or the control unit needs a diagnosis in a workshop.

Before you start

Keep your vehicle’s owner’s manual at hand. It shows where the fuse boxes are and gives the fuse chart, the list that matches each fuse to a piece of equipment. Have a spare fuse with the same amperage, the current in amps printed on the fuse.

Warning: a closing window can cause serious injury. During the tests, keep your hands, arms and head inside the car and make sure nothing is in the way of the glass. If something gets caught, reverse the window at once by pressing the same switch.

  • Switch the ignition off whenever you are not operating the windows, and always before touching the fuses. Never work on a live circuit.
  • Do not touch the airbags, the seat belt pretensioners or the high-voltage system of a hybrid or electric vehicle.
  • A red warning light means you must stop the vehicle. These checks do not replace a diagnosis in a workshop.
  • Replace a fuse only with one of the same amperage: a rating that is too high overheats the electrical system and creates a fire risk.
  • Never leave a child, a dependent adult or an animal alone in the vehicle, and take the key with you when you leave it, even briefly.
  • Do not rest any object on a partly open window: the window regulator can be damaged.
  • Do not remove the door panel or the mechanism. Opening the door can void the warranty: check when your vehicle’s warranty ends before you do anything.

Solution 1: check the rear-window lockout

The driver can disable the rear window controls from their own switch panel. This is the first thing to check when a rear window does not respond.

  1. On the driver’s switch panel, find the switch that disables the rear windows (item 3 on the Dacia Spring).
  2. Make sure this switch is not blocking the rear windows; press it if it is in the lockout position, as your owner’s manual describes.
  3. Test each rear window from its own switch in the rear seats (item 4 on the Spring).
  4. Test each front window from its switch: press the bottom of the switch to lower the window, the top to raise it.
vitre-electrique-ne-fonctionne-plus-1-1024x576 Power window not working: what can you check yourself first?
The driver's switch can disable the rear windows.

The rear windows should respond to their switches again.

Good to know: depending on the version, the Dacia Spring has manual rear windows with a crank.

Advertisement

If the rear windows still do nothing, check the fuse of the child safety relay, which appears in the Spring’s fuse list depending on the equipment level (solution 3).

Solution 2: reset the window after the battery was disconnected (Peugeot 208 and 508)

This procedure resets the anti-pinch function, the safety feature that protects against pinching as the window closes. The Peugeot 208 and 508 handbooks require it after the battery is reconnected, for example after a flat car battery.

Warning: the anti-pinch function is off during the whole procedure. Keep your hands out of the window’s path.

  1. Lower the window all the way.
  2. Raise it again: it rises only in jerks of a few centimeters with each press.
  3. Keep pressing until the window is fully closed.
  4. With the window closed, hold the switch in the up position for at least 1 second.

The window should now close with a single press.

For Renault, Dacia, Citroën, Volkswagen or Toyota, we have not read an official procedure, and the window section of the Dacia Spring manual describes none. Follow your vehicle’s owner’s manual, which is specific to each model, rather than a method from another brand.

Solution 3: check the power window fuse

The Dacia Spring manual tells you to check the fuses when an electrical device stops working. There is no universal rating for window regulators: only the chart in your owner’s manual is authoritative. With the ignition off, proceed as you would for a cigarette lighter that stopped working.

Advertisement
  1. Open your owner’s manual at the fuse chart and note the location and amperage of the window regulator fuse.
  2. Open the fuse box cover: on the Dacia Spring, pull cover A by its lower edge, or cover B depending on the vehicle.
  3. Take the fuse puller stored on the back of the cover.
  4. Pull the fuse out with the puller, then slide it out sideways.
  5. Replace a blown fuse with one of the same amperage, never a stronger one.
vitre-electrique-ne-fonctionne-plus-2-1024x576 Power window not working: what can you check yourself first?
A fuse is always replaced with one of the same amperage.

The window should respond to its switch again. On the Dacia Spring, the list includes a “front window regulator” fuse and a “child safety relay” fuse, depending on the equipment level. Do not use the empty slots in the box.

Tip: the brand’s dealers sell an emergency box with an assortment of fuses.

To keep the right rating at hand, here is an assortment of car fuses with a puller and tester.

vitre-electrique-ne-fonctionne-plus-300x169 Power window not working: what can you check yourself first?

Assortment of 306 car fuses, standard and mini blade, with puller and tester

A box of spare blade fuses in the common ratings, with a puller and a tester to check them. Handy to keep in the glove box.

If nothing works

Stop if the window still does not respond after these three checks, or if a new fuse blows again. The fault is then in the motor, the mechanism or the control unit. Take the vehicle to a garage or the brand’s dealer network.

To save time at the workshop, note the model and year of the vehicle (from the registration document) and which window is affected. Add what you hear when you press the switch, motor noise or silence, and what you have already tried: unlocking, reset, fuse replaced. Also mention a recent battery disconnection.

Take better care of your car: our toolbox

A few products to check your car’s electrical circuit and troubleshoot safely.

  • Assortment of 306 car fuses, standard and mini blade, with puller and testerA box of spare blade fuses in the common ratings, with a puller and a tester to check them. Handy to keep in the glove box.AmazonSee at Amazon
  • AstroAI digital multimeter, 2000 countsMeasures DC and AC voltage, current and continuity. Lets you check whether a socket or a fuse really delivers power.AmazonSee at Amazon
  • Mechanix Wear Original Covert mechanic glovesClose-fitting work gloves that protect the hands when working under the bonnet. They keep a good grip on tools and clamps.AmazonSee at Amazon
  • NOCO Boost GB40 jump starter, 1000 ACompact lithium jump starter with a built-in LED light and a USB output. It works from -30 to +50 °C.AmazonSee at Amazon

Frequently asked questions

Why is my power window not working?

The causes you can check yourself are the rear-window lockout set by the driver, a fuse and, after the battery was disconnected, the anti-pinch function that needs a reset. If all three are fine, the fault lies in the switch, the motor or the mechanism. That diagnosis is done in a workshop.

What should I do if the power window button stops working?

For a rear window, first check that the driver has not disabled the rear windows from their switch panel. Then test the window from its own switch and check the window regulator fuse in your owner’s manual chart. If nothing changes, the switch, the motor or the mechanism is a job for a workshop.

Where is the power window fuse?

The location and amperage of the window regulator fuse change from one brand and model to another: the fuse chart in your owner’s manual shows them. On the Dacia Spring, the fuse box is behind cover A, which you pull by its lower edge, or cover B depending on the vehicle. Its list includes a “front window regulator” fuse and a “child safety relay” fuse, depending on the equipment level.

How do I reset a power window after changing the battery?

On the Peugeot 208 and 508, lower the window all the way, raise it press by press until it is fully closed, then hold the switch up for at least 1 second. The anti-pinch function stays off during the procedure: keep your hands out of the window’s path. For other brands, follow the procedure in your owner’s manual.

Share this content:

Leave a Reply

Your email address will not be published. Required fields are marked *