This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.
Winterizing a robot lawn mower should happen before the first frost: Gardena advises bringing it in by late October or early November, because its battery can’t take freezing temperatures. Plan on 45 minutes to charge and switch off the mower, clean it, change the blades, store it somewhere dry and decide what to do with the charging station. The examples come from the Husqvarna (Automower) and Gardena (Sileno) guides; for any other brand, follow the manufacturer’s manual.
Common symptoms and causes
- Cold, snow and rain can damage a mower left outside and shorten its life.
- The mower’s battery can’t withstand freezing temperatures.
- A battery stored without a full charge risks being damaged.
- On Gardena Sileno models, a frost sensor stops the schedule when frost approaches: it’s your reminder that it’s time to winterize the mower.
Before you start
Warning: never puncture, bend or heat a lithium battery. A swollen battery won’t charge again and must go to a collection point. Work on a non-flammable surface.
Warning: unplug the charging station from the mains before taking it apart or disconnecting its cables, and never work on a device that’s plugged in. The capacitors in some appliances (TVs, microwaves, power supplies) stay charged after unplugging: don’t touch them.
Warning: stop the mower and wait until the blades have fully stopped before doing anything. Wear gloves when handling the cutting disc and blades.
Warning: opening the device may void the warranty, so check the warranty end date first. With Gardena, the 5-year warranty requires registering the mower within 3 months, and it doesn’t cover batteries.
Keep your model’s manual within reach: the shutdown procedure and the charging needed during storage vary from one mower to another. For Automower models, the guides we read don’t detail shutting down through the menu or PIN code, so follow the manual. For Worx, Stihl or Bosch, we haven’t read a winterizing guide from the manufacturer: its manual is the authority.
Good to know: if your Automower has GeoFence (the robot’s geographic safety zone), leave it enabled while the mower stays in storage inside that zone. Disable it before powering off if you store the mower somewhere else, and before dropping it off at a dealer.
Tip: for the last cuts of the season, Husqvarna suggests leaving the grass a little longer, around 6 to 8 cm (2.5 to 3 in).
Step 1: charge the robot lawn mower battery before winter
Gardena calls a full charge the most important step of winterizing. Only switch the mower off afterwards.
- Leave the mower on its station until the battery is fully charged.
- On a Gardena Sileno city or Sileno life, hold down the on/off button until the mowing menu switches off.
- On a Sileno minimo, hold the same button until all the LEDs go out.
- On an Automower, switch the robot off following the procedure in your model’s manual.
The mower should be off, with its screen or lights out and a full battery.
Good to know: according to Husqvarna, most Automower models don’t need recharging during storage. Some older models need a charge every 3 months, which their manual states. Gardena gives no recharge interval.
Step 2: clean the mower and check for wear
- Remove grass and debris from the moving parts.
- Clean the body, the chassis and the cutting disc.
- Spin each wheel by hand and listen for squeaks, rubbing or tight spots.
- Check the wear on the lower bearings of the front wheel.
- Inspect the charging contacts on the mower and the station: clear any debris and note any sign of corrosion.
- On a Gardena, remove grass and dust from the rear compartment that houses the two charging poles.
- Lightly sand these poles with emery cloth or a finely rough surface.
- Wipe the poles until they’re dry.
- Clean the charging station.
- Make a note of damaged or worn parts, for the service in step 3.
The mower should be clean and dry, with clean charging contacts.
To clean the mower and the charging poles, a complete maintenance kit saves you hunting for each tool.

Gardena 4067-20: cleaning and maintenance kit for robotic lawn mowers
Abrasive pad, brushes, plastic cleaning spray and screwdriver in a single kit. It cleans the robot and freshens up the charging contacts.
- AmazonSee at Amazon

Good to know: the Husqvarna and Gardena guides we read say nothing about cleaning with water or a hose. Check what your model’s manual allows before wetting the mower.
Step 3: change the blades and have the mower serviced
- With the mower off and gloves on, replace the blades and their screws with new ones before storage: they won’t rust over the winter and they’ll cut cleanly in spring.
- Choose original blades and screws, as Gardena requires.
- Book the annual service with your dealer or a partner installer, before the new season starts.
The blades should be new and firmly fixed, and the service scheduled.
For original Gardena blades, here is the set that fits Gardena mowers; for an Automower, a compatible set comes second.
- Gardena 4087-20: 9 original replacement blades with screws for robotic lawn mowersNine sharp blades and nine screws to replace those on the cutting disc. A fresh set before storage means a clean cut when mowing resumes.AmazonSee at Amazon
- ECENCE: 18 titanium-coated replacement blades with screws for Husqvarna AutomowerEighteen blades with screws, compatible with many Husqvarna Automower robots and other brands. They let you change every blade on the disc in one go.AmazonSee at Amazon
The Husqvarna annual service covers wear parts, a firmware update (the robot’s internal software), a deep clean, blades, a battery test and safety tests; its content varies by country and dealer. Gardena describes a similar service through its partner installers.
Good to know: Husqvarna Warranty Plus, Service Plus and Lease Plus contracts may include servicing and winter storage. Some dealers also offer a mower storage service.
Step 4: store the robot lawn mower for winter, dry and frost-free
- Choose an indoor, dry spot (garage, shed, basement) where the temperature stays above 0 °C (32 °F).
- Stand the mower on its four wheels on a flat surface.
- Failing that, hang it on the wall using a wall bracket made for your model, such as the Automower wall bracket.
The mower should spend the winter sheltered from frost and damp.
Tip: don’t put anything on top of a mower stored flat. A cardboard box or tools piled on it all winter can mark the body.
Step 5: the charging station in winter
The two brands don’t say the same thing. Husqvarna strongly recommends bringing the station and its power supply indoors; Gardena allows it to stay outside, plugged in and protected.
The boundary wire (the buried wire that marks out the mowing area) and the guide wire (the one that leads the mower back to its station) stay in the lawn all winter, either way.
Warning: on Automower EPOS models, which locate themselves by satellite with no boundary wire, bringing the reference station indoors means putting it back in exactly the same spot in spring, or you’ll have to redraw the virtual boundaries of the mowing area. It’s weatherproof and can stay outside all year, plugged in. If you bring it in anyway, store it between -20 and 70 °C (-4 to 158 °F).
If you bring the station indoors
- Unplug the station’s power supply from the mains.
- Disconnect the boundary wire and the guide wire from the station.
- Protect the cable ends from moisture in a protective box or an Automower connector box.
- Label each cable so you can reconnect it in the right place in spring.
- On a Gardena station, remove the charging tower with a screwdriver.
- Unscrew the charging plate from the ground.
- On an Automower NERA, bring in only the upper part of the station and leave the base plate outside.
- Store the station and its power supply somewhere dry and frost-free.
The station should be sheltered, and the cables left in the ground protected and easy to identify.
Tip: before unplugging, take a photo of the station’s connections. In spring, it’s worth more than any label.

If the station stays outside
- Leave the station plugged into the mains.
- Leave the boundary wire and the guide wire connected to the station.
- Cover the station, for example with a tarp.
The station should stay powered and protected from the weather until spring.
Step 6: after winter storage, putting the mower back into service
- Wait until nights no longer drop below 5 °C (41 °F) and days hover around 10 °C (50 °F).
- Clean the mower and its charging poles before the first cut.
The mower should be clean, with clean charging poles, before its first outing.
Good to know: the guides we read don’t detail how to put the station and cables back in place or how to restart the mower: your model’s manual is the authority. Husqvarna has a page on preparing the Automower for spring, which we couldn’t read. If the mower can’t find its station after being put back into service, follow our guide robot lawn mower not returning to its charging station.
If nothing works
If the mower won’t charge in spring, or if the battery looks swollen or faulty, stop there. Don’t try to open the mower or force a charge: contact your dealer or the brand’s customer service.
With Gardena, have your warranty registration proof ready, bearing in mind that the battery isn’t covered.
For a regular lawn mower that won’t start after winter, see our guide lawn mower won’t start.
Take better care of your robotic lawn mower: our toolbox
Everything to maintain the robot before winter and protect the charging station and cables through the cold season.
- Gardena 4087-20: 9 original replacement blades with screws for robotic lawn mowersNine sharp blades and nine screws to replace those on the cutting disc. A fresh set before storage means a clean cut when mowing resumes.AmazonSee at Amazon
- ECENCE: 18 titanium-coated replacement blades with screws for Husqvarna AutomowerEighteen blades with screws, compatible with many Husqvarna Automower robots and other brands. They let you change every blade on the disc in one go.AmazonSee at Amazon
- Gardena 4067-20: cleaning and maintenance kit for robotic lawn mowersAbrasive pad, brushes, plastic cleaning spray and screwdriver in a single kit. It cleans the robot and freshens up the charging contacts.AmazonSee at Amazon
- Gardena 4007-60: shelter for robotic lawn mower and charging stationShelter with a flip-top lid that sits over the charging station. It protects against rain and sun.AmazonSee at Amazon
- ECENCE: 20 gel-filled waterproof connectors for robotic lawn mower boundary wireGel-filled connectors that join or repair a boundary wire and keep moisture out. Useful to protect cable ends left outdoors.AmazonSee at Amazon
Frequently asked questions
Should you bring a robot lawn mower indoors for winter?
Yes, Husqvarna and Gardena both advise storing it indoors, dry and frost-free. The mower’s battery can’t withstand freezing temperatures, and cold, snow and rain shorten its life. Gardena puts the right time at late October or early November, before temperatures drop below zero.
How do you store a robot lawn mower battery over winter?
Charge it fully, switch the mower off, then store it in a dry room where the temperature stays above 0 °C (32 °F). Most Automower models don’t need recharging during storage, but some older models need a charge every 3 months.
Should you unplug a robot lawn mower’s charging station in winter?
Yes if you bring it indoors, which Husqvarna strongly recommends: unplug the power supply, then disconnect and protect the cables. If it stays outside, do the opposite and leave it plugged into the mains and connected to the cables, protected for example with a tarp, as Gardena allows. The reference station of Automower EPOS models can stay outside, plugged in, all year.
When should you restart a robot lawn mower in spring?
Gardena advises taking it back out once nights no longer drop below 5 °C (41 °F) and days reach about 10 °C (50 °F). Clean the mower and its charging poles first.
Share this content:
