Advertisement
Cameras

What Are the Most Common Fujifilm X-T5 Problems and Fixes?

Battery drain, a camera that won't turn on, CARD ERROR, autofocus that hunts: the causes and fixes from the Fujifilm manual for the X-T5. Exact menus, firmware 4.32 and reset.

Updated 6 min read

Mirrorless camera with a warning sign, a magnifying glass and a repair wrench
Table of contents
  1. Common symptoms and causes of X-T5 problems
  2. Before you start
  3. Solution 1: the X-T5 won’t turn on, shuts off or overheats
    1. The camera shuts off during video
  4. Solution 2: the X-T5 battery drains fast or won’t charge
    1. The battery won’t charge
    2. Battery life melts away
  5. Solution 3: the SD card shows an error
  6. Solution 4: autofocus hunts or the lens shows an error
  7. Solution 5: smartphone connection, firmware and reset
    1. The smartphone won’t connect
    2. Update the X-T5 firmware
    3. Reset the settings
  8. If nothing works
  9. Take better care of your X-T5: our toolbox
  10. Frequently asked questions
    1. Why won’t my Fujifilm X-T5 turn on?
    2. Why does the X-T5 battery drain fast?
    3. Which SD card should I choose for the X-T5?
    4. How do I update the X-T5 firmware?
    5. How do I reset a Fujifilm X-T5?

Updated on November 11, 2026

This article contains affiliate links: if you buy through them, Wanda-techs earns a commission at no extra cost to you.

Advertisement

Fujifilm X-T5 problems usually come down to the battery, the memory card, the lens or one setting, and the Fujifilm manual lists the cause of each: a battery that drains fast, a camera that won’t turn on, a CARD ERROR message or autofocus that hunts. Start with a charged, genuine battery, then work through the solutions in order.

Common symptoms and causes of X-T5 problems

  • Short battery life: cold, dirty terminals, pre-AF, BOOST mode, Bluetooth or an aging battery.
  • The camera won’t turn on: empty or badly seated battery, battery compartment cover not latched.
  • The camera shuts off during video: a temperature warning, the camera is protecting itself.
  • CARD ERROR or CARD NOT INITIALIZED: card not formatted in the camera, dirty contacts or an incompatible card.
  • No focus: a subject that is hard for autofocus, a focus area that is too small, subject detection turned off or a lens error.
  • No smartphone connection: distance, interference, or another smartphone already connected.

Before you start

  • Use the genuine Fujifilm NP-W235 battery, charged: it ships empty, and another battery can cause malfunctions.
  • Note the firmware version, the camera’s internal software: turn the camera on while holding DISP/BACK, with a card inserted. Fujifilm’s official page lists version 4.32 as the latest, while the basic manual still cites 4.30.
  • Copy your photos to a computer before any formatting or reset.

Warning: never puncture, bend or heat a lithium battery; a swollen battery will no longer charge and goes to a collection point; work on a non-flammable surface. Don’t short-circuit the terminals, don’t stick a label on them and don’t charge the battery below 5 °C (41 °F) or above 40 °C (104 °F). Never open the battery compartment while the camera is on, and know that the battery can be hot.

Warning: formatting and resetting erase data, so back up first. Formatting erases every photo on the card, protected ones included, INITIALIZE resets your settings and a firmware update can’t be undone.

Warning: opening the camera may void the warranty; check the warranty end date first. Losing power in the middle of a firmware update can leave the camera unusable.

Solution 1: the X-T5 won’t turn on, shuts off or overheats

  1. Set the ON/OFF switch to ON.
  2. Recharge the battery, or insert a charged spare.
  3. Turn the camera off, then remove the battery.
  4. Reinsert the battery the right way round.
  5. Close the compartment cover until it latches.
  6. If the screen stays black after a very fast off and on, hold the shutter button halfway down until the screen comes on.

The screen should light up. A camera that cuts out suddenly has a drained battery. After an automatic shutdown caused by inactivity, press the shutter button halfway, or move the switch to OFF and back to ON.

Good to know: if the camera refuses to turn off, it is busy; check the indicator lamp.

Advertisement

The camera shuts off during video

The camera turns itself off to protect itself when its temperature or the battery’s rises, after a warning on screen.

  1. Turn the camera off and let it cool down.
  2. For a long shoot, set D SET UP > POWER MANAGEMENT > AUTO POWER OFF TEMP. to HIGH, with the camera on a tripod.

Once cooled, the camera records again. The HIGH setting exposes you to low-temperature burns with prolonged contact: don’t hold the camera in your hands. It works between 0 and +40 °C (32 to 104 °F); don’t leave it in the sun or in a closed car.

Solution 2: the X-T5 battery drains fast or won’t charge

The battery won’t charge

  1. Turn the camera off: the battery doesn’t charge while the camera is on.
  2. Plug it in over USB-C using the supplied AC adapter: about 180 minutes to charge, against 600 on a computer.
  3. Watch the charge lamp: lit, charging is in progress; off, it is finished; blinking, there is an error.
  4. If the lamp blinks, clean the battery terminals with a soft, dry cloth.
  5. Open D USER SETTING > BATTERY AGE and replace the battery if it is old.

The lamp should stay lit during charging, then go off.

Battery life melts away

  1. Warm a cold battery in a pocket before using it.
  2. Set D SET UP > POWER MANAGEMENT > PERFORMANCE to NORMAL, or to ECONOMY, which limits autofocus and the viewfinder but extends battery life.
  3. Set D SET UP > POWER MANAGEMENT > AUTO POWER OFF to a short delay, 1 min or 30 s for example.
  4. Set pre-AF to OFF in the G AF/MF SETTING menu (the PRE-AF option).
  5. Set I NETWORK/USB SETTING > Bluetooth/SMARTPHONE SETTING > Bluetooth ON/OFF to OFF when you’re not transferring photos.
  6. If battery life stays short, replace the worn battery with a genuine NP-W235.

The camera should last longer between charges.

If the battery is worn out, here is the genuine Fujifilm NP-W235 battery.

refresh-195803-300x169 What Are the Most Common Fujifilm X-T5 Problems and Fixes?

Fujifilm NP-W235: original lithium-ion battery

Original spare battery for the Fujifilm bodies that use it, including the X-T5. It extends a day of shooting or replaces a worn-out battery.

refresh-195803-1-1024x576 What Are the Most Common Fujifilm X-T5 Problems and Fixes?
ECONOMY mode, a short auto power off and Bluetooth off: battery life recovers.

Solution 3: the SD card shows an error

CARD NOT INITIALIZED means a card that isn’t formatted, or was formatted on a computer or another camera. BUSY signals an incorrect format, to be redone in the camera. CARD ERROR comes from a card not formatted for the camera, dirty contacts, or a damaged or incompatible card.

Advertisement
  1. Turn the camera off, remove the card and clean its contacts with a soft, dry cloth.
  2. If PROTECTED CARD appears, check that the card’s write-protect switch isn’t in the locked position.
  3. Copy your photos to a computer: the next step erases the whole card, protected images included.
  4. Open D USER SETTING > FORMAT.
  5. Choose the card slot, press MENU/OK, then confirm with OK.
  6. Wait for formatting to finish without turning the camera off or removing the card.
  7. If the error comes back, try another compatible card.

The message should disappear and the camera record again.

Tip: format any new card, or one that has been in a computer, in the camera before the first photo.

The X-T5 takes SD, SDHC and SDXC cards, UHS-I or UHS-II, in both slots. Our guide to recognizing a good SD memory card explains the speed logos.

For bursts and demanding video, here is a UHS-II SD card suited to both slots.

refresh-195803-300x169 What Are the Most Common Fujifilm X-T5 Problems and Fixes?

SanDisk Extreme PRO 128 GB SDXC UHS-II V90

Fast UHS-II SD card for burst shooting and demanding video. Format it in the camera before first use.

Solution 4: autofocus hunts or the lens shows an error

Red focus icon, red frame: the camera is telling you it didn’t achieve focus.

  1. Enlarge the focus area by a few steps.
  2. Open G AF/MF SETTING > SUBJECT DETECTION SETTING and check that detection isn’t set to OFF.
  3. If the subject stays difficult, focus on an object at the same distance, keep focus locked and reframe.
  4. Clean the lens if it is dirty or obstructed.

The icon and frame should no longer turn red.

In case of FOCUS ERROR, LENS ERROR or LENS CONTROL ERROR:

  1. Turn the camera off.
  2. Remove the lens and look for a foreign object between the lens and the body.
  3. Reattach the lens: align the marks and turn until it clicks.
  4. Turn the camera back on.

The message should disappear.

Solution 5: smartphone connection, firmware and reset

The smartphone won’t connect

  1. Update the FUJIFILM XApp application.
  2. Move the smartphone closer, away from a microwave or a cordless phone.
  3. Turn off Bluetooth on other smartphones nearby: the camera connects to only one at a time.
  4. Check that the camera’s airplane mode is off, because it cuts Wi-Fi and Bluetooth.
  5. Open I NETWORK/USB SETTING > Bluetooth/SMARTPHONE SETTING and restart PAIRING REGISTRATION, with the app open on the smartphone.

The next step erases all the camera’s wireless settings.

  1. Choose I NETWORK/USB SETTING > RESET WIRELESS SETTING.

The camera should connect to the app.

Update the X-T5 firmware

Step 2 formats a card, which erases its contents. The update can’t be undone, and the camera must not turn off during the operation.

  1. Download the latest version file from the X-T5 firmware page on Fujifilm’s site.
  2. Format a card in the camera, which erases its contents, then copy the file FWUP0030.DAT onto it.
  3. Fully charge the battery.
  4. Insert the card and turn the camera on while holding DISP/BACK, or use the firmware option in the user settings menu.
  5. Follow the update on the rear screen: the viewfinder stays off during the operation.
  6. Leave the camera on until it finishes, up to about 10 minutes according to the manual, 5 minutes according to Fujifilm’s page.
  7. Turn the camera off and on again.

Holding DISP/BACK at startup should now show the new version.

refresh-195803-2-1024x576 What Are the Most Common Fujifilm X-T5 Problems and Fixes?
The firmware file goes through a card formatted in the camera.

Reset the settings

These options reset settings to zero: note the ones you want to keep.

  1. Open D USER SETTING > RESET.
  2. Choose a targeted reset first: STILL MENU RESET, MOVIE MENU RESET or SET-UP RESET, labels from the English manual.

The next option erases all your settings, except the custom white balance.

  1. As a last resort, choose INITIALIZE and confirm.

The chosen settings should return to their original values.

If nothing works

Stop if FOCUS ERROR, LENS ERROR or CARD ERROR persists after cleaning, formatting and trying another card or lens, or if the camera won’t turn on with a charged genuine battery. Then contact the retailer or the Fujifilm distributor in your country for service and warranty.

Have the serial number, the firmware version, the purchase date with the invoice and the exact error message on hand.

Own a Canon DSLR too? Our guide to common Canon EOS 2000D problems follows the same method.

Take better care of your X-T5: our toolbox

A second battery, a dual charger and a few accessories prevent many breakdowns on the road.

  • Fujifilm NP-W235: original lithium-ion batteryOriginal spare battery for the Fujifilm bodies that use it, including the X-T5. It extends a day of shooting or replaces a worn-out battery.AmazonSee at Amazon
  • Fujifilm BC-W235: dual charger for NP-W235 batteriesCharges two NP-W235 batteries at the same time, without tying up the camera. Handy for setting off with two full batteries.AmazonSee at Amazon
  • SanDisk Extreme PRO 128 GB SDXC UHS-II V90Fast UHS-II SD card for burst shooting and demanding video. Format it in the camera before first use.AmazonSee at Amazon
  • SanDisk Extreme PRO: UHS-II USB-C SD card readerReads UHS-II SD cards at full speed on a computer with a USB-C port. It speeds up copying photos before a format.AmazonSee at Amazon
  • Giottos Rocket Air Blaster: large air blowerBlows dust off the sensor, lens and viewfinder without touching them. Its valve stops it drawing dust back in.AmazonSee at Amazon

Frequently asked questions

Why won’t my Fujifilm X-T5 turn on?

The battery is empty or badly seated, or its compartment cover isn’t latched. The battery ships uncharged, and the camera won’t start until it is charged. If nothing changes with a charged genuine battery, contact the retailer.

Why does the X-T5 battery drain fast?

Cold, dirty terminals, pre-AF, BOOST mode and Bluetooth left on drain the battery faster. If nothing changes after solution 2, check the battery’s age in D USER SETTING > BATTERY AGE and replace it if it is old.

Which SD card should I choose for the X-T5?

Fujifilm recommends a UHS-II card for bursts. For video at 360 Mbps you need a V60 card or better; at 100 or 200 Mbps, UHS Speed Class 3 is enough. Format it in the camera before first use.

How do I update the X-T5 firmware?

Copy the file from Fujifilm’s site onto a card formatted in the camera, then start the update from the firmware option in the user settings menu. Keep the battery charged and don’t turn the camera off during the operation, which can’t be undone.

How do I reset a Fujifilm X-T5?

Open D USER SETTING > RESET and choose a targeted reset first, such as STILL MENU RESET or SET-UP RESET. INITIALIZE erases all your settings, except the custom white balance. Note the ones you want to keep beforehand.

Share this content:

Leave a Reply

Your email address will not be published. Required fields are marked *